Filter
Top Products
10
Checking Signal information
(Continued)
■ Checking Signal information
Press a/b to select “Signal information”.
Signal information
Auto search
Manual search
Manual adjust
Antenna power
Signal strength
Signal quality
Current Maximum
Channel number
100
Current Maximum
98
100
98
68
4 Position and align the antenna so that the
maximum possible values for “Signal strength”
and “Signal quality” are obtained.
NOTE
• The values of “Signal strength” and “Signal quality” indicate
when to check the appropriate alignment of the antenna.
Auto installation
You can run auto installation again, even after setting up
the preset channels.
1 Press MENU and the MENU screen displays.
2 Press c/d to select “Setup”.
3 Press a/b to select “Auto installation”, and then
press ENTER.
4 If you have already set the password, enter it here.
• See page 14 for setting a password.
5 Press c/d to select “Yes”, and then press
ENTER.
6 Press a/b/c/d to select “DTV”, “ATV” or “ATV
+ DTV”, and then press ENTER.
Press a/b to select the desired sound system,
and then press ENTER.
• Sound system is selectable when the signal search is set
to “ATV” or “ATV + DTV” mode only.
You do not need to do anything during the auto
search. Press MENU to exit.
Programme setup
Digital settings
You can reconfigure DTV services settings automatically
or manually.
1 Press MENU and the MENU screen displays.
2 Press c/d to select “Setup”.
3 Press a/b to select “Digital programme setup”,
and then press ENTER. If you have already set the
password, enter it here.
• See page 14 for setting a password.
4 Press a/b to select the desired menu item, and
then press ENTER.
5 Press c/d to select “Yes”, and then press
ENTER.
■ Auto search (Digital)
Use this menu to add new services automatically after
auto installation has been completed.
■ Manual search (Digital)
Add new services within a specified frequency band.
• Press c/d to select the frequency and then press ENTER.
■ Manual adjust (Digital)
Configure various settings for each service using the
Colour (R, G, B) buttons.
Digital programme setup]
1 Press a/b to select desired service.
2 Press the colour button on the remote control
corresponding with the item you want to
reconfigure.
• Each time the colour button is pressed, you can switch
the corresponding operation on/off.
Buttons for Manual adjust operation
Menu
items
Remote
control
buttons
Description
Lock R
When the service is locked, you must
enter your password whenever you
tune to the service.
CH Skip G
Services with “Skip” are passed over
when pressing r/s in the TV/
remote control unit.
Sort B
The item position of services can be
sorted.