Filter
Top Products
Supplied accessories
Make sure the following accessories are provided with the product.
NOTE
• Always use the AC cord supplied with the TV.
• AC cord enclosed in this product is for 110-125V. In using it on the 125-240V AC, please consult to the following.
SHARP ELECTRONICS CORPORATION
6100 Blue Lagoon Drive, Suite 230, Miami, Florida 33126, U.S.A.
QUICK REFERENCE
Remote control unit (
g
1)
“AAA” size battery (
g
2)
Page 8
AC cord
(
g
1)
Page 7
Stand unit
(
g
1)
Page 6
Cable Clamp (
g
2)
Cable tie (
g
1)
Page 7
Attaching the stand
• Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal.
•
Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.
Operation manual
(
g
1)
Attach the two supporting posts for the stand
unit onto the base using the box for the stand
unit as shown below.
2
2
3
3
1
1
2
1 Insert each of the protrusions on the two supporting
posts into the openings on the upper side of the
base.
2 Insert and tighten the 6 short screws with the hex
key (supplied with the product) in the order of 1,
2 and 3.
(Close-up of the upper side of the stand unit)
6
NOTE
• To detach the stand, perform the steps in reverse order.
1
Insert the stand into the openings on the
bottom of the TV.
2
Insert and tighten the 4 long screws into
the 4 holes on the rear of the TV.
22
1
Hex key
Long screw
CAUTION
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
3
1
Confi rm that there are 10 screws (6 short
screws and 4 long screws) supplied with the
stand unit.
Soft cushion
Short screw
Hex key