Filter
Top Products
15
Easy Start
1 After the projector turns on, the Setup Guide appears.
(When “Setup Guide” is set to “On”. See page
45.)
2
Follow the steps in the Setup Guide and adjust the focus, height (angle) and picture size.
3 After adjusting the focus, height (angle) and picture size, press ENTER to fi nish the
Setup Guide.
4. Adjust the projected image with the Setup Guide
_P. 24
Correcting trapezoidal distortion using Keystone Correction.
On the remote control
Shrinks
upper side.
Shrinks
lower side.
5. Correct trapezoidal distortion
_P. 26
Press INPUT P/R to display the INPUT list. Use INPUT P/R to select the Input mode.
On the
projector
On the remote
control
INPUT list
Audio
INPUT
H
V
COMPUTER
HDMI
VIDEO
When you select HDMI input, use O/Q to select the audio input terminal (HDMI or AUDIO).
6. Select the Input mode
_P. 27
7. Turn the computer on
Press STANDBY/ON on the projector or STANDBY on the remote control, and then press
the button again while the confi rmation message is displayed to put the projector into
Standby mode.
On-screen display
On the
projector
On the remote
control
8. Turn the power off
_P. 23