Filter
Top Products
20
E
Press-and-tap
Same action as right-clicking a mouse.
With one nger touching the screen, tap once (single tap) with
another nger.
With one nger touching
Tap once (single tap) with another nger
TIPS
• The screen may not respond correctly in the following
cases:
Touching is too quick
The distance between the two points is too short
The two points intersect
• Operation with the touch pen is not possible.
n
Pen actions
Pen tip
Function Button 2
Function Button 1
Ultrasonic transmitter
Battery indicator
Function Button 1
Pressing Function Button 1 has the same action as right-
clicking a mouse.
The battery indicator illuminates.
Function Button 2
In the Pen Software, pressing Function Button 2 has the
action that is set in the Pen Software.
The battery indicator illuminates.
TIPS
• Use Function Button 1 and Function Button 2 near the front
of the screen. If too far away, operation will not be possible.
• Press Function Button 1 and Function Button 2 slowly
and rmly. If pressed too quickly, the action will not be
recognized.
• If the pen tip becomes worn or damaged, replace it. Pull
out the old pen tip and insert a new pen tip.
Other functions
In Windows 7, touch pointer and input panel functions can be
used.
For information on these functions, see Windows Help.
Touch pointer :
A translucent image of a mouse appears near the point
touched. The left/right buttons of the image can be clicked
to perform the same actions as left/right clicking a mouse.
Input panel :
A software keyboard and an input panel with handwriting
recognition appear on the screen.
In Windows 7 (excluding Starter), the ink function of Microsoft
Ofce can be used.
Handwritten comments can be written, and handwriting can
be recognized.
For details, see Microsoft Ofce Help.
Cautionary points
• Do not use the touch pen for any purpose other than touch
panel operation.
• Do not press hard on the pen tip.
•
Do not cover the ultrasonic transmitter of the touch pen with
your hand or nger.
• Operation will not take place correctly if there is an obstacle
between the infrared transmitter/receiver and the touch pen
or your nger. Operation will not take place correctly if your
ngers or your sleeve is near the screen.
• If the touch pen is held too at against the screen, the
touch position may not be correctly detected.
• If the touch pen does not work at the edge of the screen,
move it slowly.
• Do not store with the pen tip of the touch pen or function
button pressed. The battery will be exhausted.
• Do not use near a device that emits ultrasonic waves. The
touch pen uses ultrasonic waves and may not operate
correctly.
• If two touch panels are used in close proximity to each
other, use handwriting mode. The touch pens will interfere
with each other and will not operate correctly.
• If there is dirt or foreign matter on the tip of the touch pen,
remove it. Foreign matter may damage the screen.
• Applications such as a screensaver or media player may
cause the resolution to automatically change. If "Resolution
Change Notice" is enabled in the touch panel driver, a
resolution change message will appear. In this case,
disable "Resolution Change Notice", or change the setting
in the application so that it does not change the resolution.
• The pen may be out of position in the login screen. In this
case, use the keyboard or mouse.
• If the USB cable becomes disconnected, the touch panel
may not operate correctly after the cable is reconnected. In
this case, restart your computer.
Eraser
The eraser is used with the Pen Software. For the procedure
for using the eraser, refer to the Pen Software Operation
Manual.
Caution
• When using the eraser, gently bring the cloth side into
contact with the screen. Touching the screen with one of
the non-cloth sides will damage the screen.
• If there is any dirt or foreign matter on the surface that
contacts the screen, remove it. Foreign matter may damage
the screen.
Touch Pen Preparations/Touch Action