Filter
Top Products
Main code Sub code Content
53 06 ADF timing sensor adjustment
When this simulation is executed, the paper exit reverse sensor original judgement level is adjusted. After
completion of this adjustment, the original judgement level is displayed on the copy quantity display.
Display range: 0 ∼ FFh (hexadecimal)
6. User simulation
This simulation allows to change and set the following setting which has been set when shipping from the factory.
(1) Functions which can be set and canceled by the user simulation
Function name Function and setting content Factory setting
Auto clear
• After completion of copying, when a certain time is passed, the machine returns to the initial state
automatically. The time to return to the initial state is set in the range of 30 - 120 sec in increment of
30 sec. This function can be cleared.
60 sec
Pre-heat
• When the copier is left without copying with the power ON, the power consumption is automatically
lowered to 60Wh. The time to start this function is set in the range of 1 min - 120 min.
15 min
• When this function operates, the pre-heat lamp on the operation panel is lighted.
To return to the initial state:
Press any key on the operation panel. (If the COPY button is pressed, the machine returns to the
initial state and performs copying.)
If also the original is set or the tray is pulled out, the machine returns to the initial state.
Auto power shut off
• When the copier is left without copying with the power ON, the power consumption is automatically
lowered to 10Wh. The time to start this function is set in the range of 5 min - 120 min.
30 min
• When this function operates, al the lamps on the operation panel except for the pre-heat lamp are
turned off.
To return to the initial state:
Press the COPY button. The machine returns to the initial state.
Auto pre-heat control
• This function learns the use conditions of the copier to automatically control the time to start the
pre-heat function and the auto power shut off function to the optimum level. This function can be
activated or inactivated.
Cancel
• When this function is activated, the time settings in the pre-heat function and the auto power shut off
function are ignored.
Auto document
feeding unit manual
document feed mode
• By use of the auto document feeder (option), originals of different sizes are fed manually.
Cancel
• When this function is activated, set an original during the original feed lamp blinks after completion
of copying of the previous original, and the original is fed automatically.
Sorter take-out mode
• When the sorter (option) is installed, the interval between bins can be extended to facilitate to take
out the copy by pressing the copy take-out key.
Set
Auto paper selection
• This function automatically selects the copy paper which is of the same size of the original (A3, B4,
A4, B5 size only) which is set on the table.
Set
Auto tray selection
• When paper is exhausted during copying, if paper of the same size is set in the same direction on
another tray, the tray is automatically selected to allow to copy.
This function can be canceled.
Set
* Note: The value of power consumption in pre-heat or in auto power shut off may vary according to the use conditions.
8 – 20