Filter
Top Products
37
Viewing an Image from a PC
Use the INPUT5 (PC-IN) terminals to connect a PC.
A
• The PC input terminals are DDC1/2B-compatible.
• Refer to page
39 for a list of PC signals compatible with the System.
• Make sure to select the same signal values for the output signal of a PC and the input signal of the LCD TV set before connecting with
the PC. (See pages 38 and 39.)
• Depending on the PC being used, images may not be shown without converting the output signals into external output. Please refer to
your PC’s manuals regarding converting to external output.
Connecting a PC
Signal names for 15-pin mini D-sub connecter
15
14
13
12
9
11
10
8
7
6
5
4
3
2
1
Pin No. Signal name Pin No. Signal name Pin No. Signal name
1 R 6 GND (Ground) q Not connected
2 G 7 GND (Ground) w SDA
3 B 8 GND (Ground) e HD
4 Not connected 9
+
5V r VD
5 CSYNC 0 GND (Ground) t SCL
A
• Pin No. 5 is not used for inputting the signal.
• Pin No. 9 is not connected with the supplied RGB cable.
Displaying an Image from a PC
Ferrite core
Connecting the RGB cable
• Connect the RGB cable making sure
that it fits correctly into the terminal.
Then, firmly secure the connectors
by tightening the screws on both
sides of the plug.
• Do not remove ferrite cores attached
to the RGB cable.
To view an image from a PC, perform the following procedure.
1
Select the INPUT5 (PC) mode using INPUT on the remote control or the LCD TV set. (See
page
18.)
2
Select the PC input signal. (See page
38.)
3
Adjust the “FINE SYNC.” items if the PC image does not come in clearly. (See page
38.)
PC
RGB cable (supplied)
To AUDIO
input terminal
To Audio output
terminal
To ANALOG
RGB terminal
To ANALOG RGB
output terminal
ø 3.5 mm stereo minijack cable
(commercially available)
LC-20D30U_E_book.indb 37 2005/12/15 11:27:39