Filter
Top Products
1
2
3
4 Insert a concrete anchor (K) into to each hole.
5
6
7
4
5
1
2
3
4
Check the mounting screws every two months for tightness.
Hook the TV rails over the top of wall plate (3-a).
If your display has a curved back or a recessed thread mounting
point, place the spacer (M) between the mounting bracket and
display and then choose screw (F/G/H) to match (figure 2-b).
If necessary, a hammer can be used to lightly tap each anchor into place so that they are flush
with the wall.
Maintenance
According to the size of display's hole, choose the corresponding
screw and hole on the rectangle washer, then thread them in line
as shown (figure 2-a).
Step 2 Display Bracket Installation
The TV rail can be tilted down up to 15 degrees. To make this adjustment, first loosen the knob and pull or
push the rail until it is in the desired position. Once the desired level of tilt is achieved, re-tighten the mount by
turning the tension knobs (figure 3-b).
On the TV rail equipped with lock, lock it to avoid the theft by rotating the key until the hook touches the bottom
bar of the wall plate (3-c)
To ensure optimal installation, this kit includes various screws of
different diameters and lengths.
1
2
Determine which screw (A/B/C/D/E/F/G/H) is of the correct length
by carefully inserting a straw, or toothpick, and mark how deep
the mounting point is.
3
Mark four holes to be used for securing the mount and place the
wall plate aside (figure 1-d).
Drill holes using an electric drill and 1/2" masonry bit to a depth of
3".
On the TV rail equipped with screw, rotate the long screw at the bottom of the display rail to tighten it & secure
mount (figure 3-d).
Once all of the anchors are in place, move the wall plate back into position. Check the bubble
level to verify that the wall plate is level.
NOTE: The concrete anchors must be used for concrete installation.
Place your TV screen down on a soft, flat surface, and locate the
threaded mounting points that are located on the back of the
display.
Attach the bubble level (L-2) to the wall plate, with the help of an
assistant place the wall plate into position against the wall, using
the bubble level to keep it level.
B) Concrete/Brick Installation
Step 3 Final Installation & Adjustment
Insert bolt (J) with washer (L-1) into each concrete anchor in the wall. Do not tighten until all
screws are in place.
4