Filter
Top Products
AG
BH
CI
DJ
EK
FL
M
(x2) cable ties (30cm)
Do not install on a structure that is prone to vibration, movement or chance of impact. Failure to do so could result in
damage to the display and/or damage to the mounting surface.
Recommended mounting surfaces: wood stud and solid-flat concrete. If the mount is to be installed on any surface other
than wood studs, use suitable hardware (not included but commercially available).
Prior to the installation of this product, the installation and operating instructions should be read and completely
understood. The installation and operating instructions must be read to prevent personal injury and property damage.
Keep these installation and operating instructions in an easily accessible location for future reference.
(×4) M5 x 16
Caution
Hardware kit:
It is recommended that two people perform the installation. Injury and/or damage can result from dropping or mishandling
the display.
CAUTION: The maximum load capacity is 100 lbs. Use with products exceeding the maximum load capacity may cause
serious injury. See apparatus instructions.
INSTALLATION AND OPERATING INSTRUCTIONS
(×6) M8 concrete anchor
(×4) M8/M6/M5 rectangular washer
(×4) M6×16 screw
(×4) M8×16 screw
(×4) M5×35 screw (×6) M8 washer
(×4) M6×35 screw
(x1) wrench
(×6) bolt
The wall structure must be capable of supporting at least the maximum load capacity as indicated. If not, the wall must be
reinforced. Proper installation procedure by yourself or a qualified service technician, as outlined in the installation
instructions, must be adhered to. Failure to do so could result in serious personal injury.
Do not install near heater, fireplace, air conditioning, in direct sunlight, or any other heat producing source. Failure to do so
may result in damage to the display and could increase the risk of fire.
When mounting to a wall that contains wood studs, confirm dead center of the wood stud prior to installation, it is
recommended that the wood studs be a minimum of 16" apart.
(×4) spacer
(×4) M8×35 screw
2