Filter
Top Products
5
B) Concrete / Brick Wall Installation
Note: The Plastic Anchors must be used for concrete and brick wall installation.
1. Attach the Bubble level to the wall plate, with
the help of an assistant place the wall plate into
position against the wall, using the bubble
level to ensure it is level (figure 1-e).
2. Mark four holes to be used for securing the
mount, and place the wall plate aside. Locate
the holes directly into the concrete or brick,
never into the mortar between the blocks.
3. Drill holes using an electric drill and 3/8" masonry drill bit to a depth of 2" at the
positions you marked.
4. Insert a Plastic Anchor (B) into each hole (figure 1-f).
5. If necessary, a hammer can be used to lightly tap each Plastic Anchor into place so that
they are flush with the wall.
6. Once all of the Plastic Anchors are in place, move the wall plate back into position. Check
the bubble level to verify that the wall plate is level.
7. Insert Bolt (A) and Washer (C) into each Plastic Anchor (B) and tighten. Do not fully
tighten until all bolts are in place (figure 1-g).
1-e
1-f
1-g