Filter
Top Products
1
2
3
4
5
3
4
5
7
8
a) Wood Stud Installation
You should mark two positions total.
Stud finder for drywall installation
NOTE: When mounting to wood studs, the two wood studs must be a minimum of 16" apart.
Use a high-quality electronic stud finder (commercially available) to locate dead center of two studs and mark
their locations with a pencil.
Step 1: Wall Plate Installation
Tools Required
1
Phillips head screw driver
Attach the bubble level (H-2) to the wall plate and with the help of an assistant ensure the wall plate is level,
position the wall plate against the wall in the desired mounting location.
Mark the right and the left positions of the small horizontal slots that are in alignment with the studs.
2
CAUTION: Do not over-tighten bolts - doing so may cause unnecessary damage to the wall.
Tighten the bolt with the 1/2" socket or 1/2" open-end wrench by turning clockwise until tight.
For each location, insert bolt (I) into the wall.
Pre-drill a 3/16" hole to a depth of approximately 3" in the wall stud at each marked location.
Level
1/2" socket & socket wrench and/or 1/2" open-end wrench
Drill, 3/16" (5mm) drill bit for wood stud installation and 1/2" (12mm) masonry drill bit for concrete/brick
installation
CAUTION: Do not release the wall plate until it is properly mounted and secured to the wall.
6 Place the wall plate against the wall and line up the mounting slots with the drilled holes. Check the bubble level
to verify that the wall plate is level.
3