Silvercrest KH 2158 Universal Remote User Manual


 
- 23 -
Volume control
Vol +/—, (Mute switching)
Press the "VOL+" button to increase the volume. With the
"VOL —" button you reduce the volume. To mute the sound
press the
-button h. A further press of this button turns
the sound back on.
When you activate the VOL +/— buttons j on the URC basi-
cally the volume adjustment on the TV device is addressed,
regardless thereof, which device button e was pressed previ-
ously. However, this does not apply to the following devices:
“AMP”, “DVD”, “ASAT”, “DSAT” and “CBL” since it can be
assumed that these devices are equipped with their own
volume control.
For operation
To operate one of the programmed devices with the URC >
rst press the corresponding device button e.
Then point the URC to this device and press the desired
button.
Put the number buttons
> o exactly as you do with the
original remote control. Before you make a two digit
entry press, if necessary, the
button a.
Press the FAV/EPG button
> 1( to start the electronic pro-
gramme guide of a device equipped with this function.
If you press the S button
> r the date is superimposed for
10 seconds in the LCD display q below and on the right.
Whilst you hold down one of the device buttons
> e the
active code for this device will be superimposed below to
the right in the LCD display q.
Via the MENU button
> k you access the dialogue for the
setting of the respective target device.
Press the illumination button
> dto switch the display and
button illuminations on and/or off.
All OFF
Tips:
With the button ALL OFF (all o) w all devices that
are switched on can be automatically switched o. This func-
tion can switch on again devices that have already been
switched o (depending on the device). For this hold down
the ALL OFF button w for approx. 5 seconds. This will only
function under the following circumstances:
1. A visible connection exists between all the devices and
the URC.
2. Automatic code search, brand code search and MACRO
function are not active.
3. All target devices must be suitable for remote control
switch o.