Filter
Top Products
32
GB
Manual Programme
Preset
Press F/f to select the programme number you want to manually tune (if tuning a
recorder, select channel 00), then press .
System/Channel
1 Press F/f to select “System”, then press .
2 Press F/f to select one of the following TV broadcast
systems, then press RETURN.
B/G: For western European countries/areas
I: For the United Kingdom
D/K: For eastern European countries/areas
L: For France
3 Press F/f to select “Channel”, then press .
4 Press F/f to select “S” (for cable channels) or “C” (for
terrestrial channels), then press g.
~
• “S” is not available when “United Kingdom” is selected for
“Country” (page 7).
5 Tune the channels as follows:
If you do not know the channel number
(frequency)
Press F/f to search for the next available channel. The
search stops when a channel is found. To continue
searching, press F/f.
If you know the channel number (frequency)
Press the number buttons to enter the channel number of
the broadcast you want to tune, or the channel number of
your recorder.
6 Press to jump to “Confirm”, then press .
Repeat the above procedure to preset other channels
manually.
Label Assigns a name of your choice, up to five letters or numbers,
to the selected channel. This name appears briefly on the
screen when you select the channel.
AFT Allows you to fine-tune the selected channel manually if you
feel that a slight tuning adjustment may improve picture
quality.
You can adjust the fine tuning over a range of –15 to +15.
When “On” is selected, fine tuning adjustments are made
automatically.
Audio Filter Improves the sound of individual channels when distortion
occurs in mono broadcasts. Sometimes a non-standard
broadcast signal can cause sound distortion or intermittent
sound muting in mono programmes.
If you do not experience any sound distortion, we recommend
that you leave this option to “Off” (factory setting).
~
• You cannot receive stereo or dual sound when “Low” or
“High” is selected.
• “Audio Filter” is not available when “System” is set to “L”.
LNA Improves the picture quality of the channel (noisy picture)
when the broadcast signal is very weak.
If you cannot see any improvement in the picture quality even
if you set to “On”, set this option to “Off” (factory setting).
Skip Skips unused analogue channels when you press PROG +/–
to select channels. To select channels you have programmed
to skip, use the corresponding number buttons.