Filter
Top Products
35
GB
Using MENU Functions
Audio Filter Improves the sound for individual channels in the case of
distortion in mono broadcasts. Sometimes a non-standard
broadcast signal can cause sound distortion or intermittent
sound muting when watching mono programmes.
If you do not experience any sound distortion, we
recommend that you leave this option set to the factory
setting “Off”.
~
• You cannot receive stereo or dual sound when “Low” or
“High” is selected.
LNA Improves the picture quality for individual channels in the
case of very weak broadcast signals (noisy picture).
If you cannot see any improvement in the picture quality even
if you set to “On”, set this option to “Off” (factory setting).
Skip Skips unused analogue channels when you press PROG +/–
to select channels. (You can still select a skipped channel
using the number buttons.)
Confirm Saves changes made to the “Manual Programme Preset”
settings.
Digital Set-up
Digital Tuning Digital Auto
Tuning
Tunes in the available digital channels.
This option allows you to retune the unit after moving house,
or to search for new channels that have been launched by
broadcasters. For details, see step 6 of “Performing the initial
set-up” (page 8).
Programme
Sorting
Removes any unwanted digital channels stored on the unit,
and changes the order of the digital channels stored on the
unit.
1 Press F/f to select the channel you want to remove or
move to a new position.
You can also select a channel by pressing the number
buttons to enter its three-digit channel number.
2 Remove or change the order of the digital channels as
follows:
To remove the digital channel
Press . After a confirmation message appears, press G
to select “Yes”, then press .
To change the order of the digital channels
Press g, then press F/f to select the new position for the
channel and press G.
3 Press RETURN.
Digital Manual
Tuning
Tunes the digital channels manually. This feature is available
when “Digital Auto Tuning” is set to “Antenna”.
1 Press the number button to select the channel number
you want to manually tune, then press F/f to tune the
channel.
2 When the available channels are found, press F/f to
select the channel you want to store, then press .
3 Press F/f to select the programme number where you
want to store the new channel, then press .
Repeat the above procedure to manually tune other channels.
(Continued)