Filter
Top Products
60
You can run the network diagnostic.
1 Select “Network Connection
Diagnostics” in “Network Settings,”
and press ENTER.
2 Select “Start,” and press ENTER.
The network diagnostic starts.
Results are displayed after the player
finishes running the network diagnostic.
If an error message appears, follow the
on-screen instructions and perform
“Network Connection Diagnostics”
again.
3 Select “Finish,” and press ENTER.
1 Connect a DLNA certified device to the
network set in “Step 4: Connecting to
the Network” on page 26, and set up
the DLNA certified device as a home
server.
For details, refer to the instruction
manual supplied with the DLNA
certified device.
b
When a firewall is set for the DLNA certified
device, disable the function. For details, refer
to the instruction manual supplied with the
DLNA certified device.
2 Press HOME.
3 Select (Setup) using </,.
4 Select “Connection Server Settings”
in “Network Settings,” and press
ENTER.
The connected server list appears.
If no server appears in the server list,
press OPTIONS to select “Update Server
List,” and press ENTER.
5 Press OPTIONS to select “Network
Diagnostic,” and press ENTER.
6 Select “Start,” and press ENTER.
The network diagnostic starts.
Results are displayed after the player
finishes running the network diagnostic.
• To display detailed results for a server,
select a server using M/m, and press
ENTER. To go back to the results
display, select “Close,” and press
ENTER.
7 Press RETURN to return to the server
list.
8 Press RETURN to exit.
To display/hide a server
1 While the connected server list is
displayed, select a server using M/m, and
press ENTER.
2 Select “Shown” or “Hidden” using M/m,
and press ENTER.
When you select “Hidden,” the server
will not be displayed in the photo
category.
z
You can hide a server in the photo category as well.
Select the server using M/m, and press OPTIONS to
select “Hidden,” then press ENTER.
</M/m/,,
ENTER
• Select an input function
using </M/m/,, and
press ENTER.
• Enter characters as
follows:
1Select a
character selection panel
using </M/m/,, and
press ENTER.
2Select a
character using </,,
and press ENTER.
Network Connection
Diagnostics
Connection Server Settings
Buttons Details