Sony BDP-SX90 Blu-ray Player User Manual


 
5
On cleaning
Clean the cabinet, panel, and controls with a
soft cloth slightly moistened with a mild
detergent solution. Do not use any type of
abrasive pad, scouring powder or solvent such
as alcohol or benzine.
Wipe the LCD surface with the soft dry cloth
lightly. To prevent dirt buildup, wipe it
frequently.
Do not wipe the LCD surface with a wet cloth.
If water enters, a malfunction may result.
If picture/sound is distorted, the lens may be
covered with dust. In this case, use a
commercially-available blower brush for
camera lenses to clean the lens.
Avoid touching the lens directly during
cleaning.
On cleaning discs, disc/lens cleaners
Do not use cleaning discs or disc/lens cleaners
(including wet or spray types). These may cause
the apparatus to malfunction.
On replacement of parts
In the events that this player is repaired, repaired
parts may be collected for reuse or recycling
purposes.
On connecting to the HDMI OUT jack
Observe the following as improper handling
may damage the HDMI OUT jack and the
connector.
Carefully align the HDMI OUT jack on the
right of the player and the HDMI connector by
checking their shapes. Make sure the
connector is not upside down or tilted.
Be sure to disconnect the HDMI cable when
moving the player.
Hold the HDMI connector straight when
connecting or disconnecting the HDMI cable.
Do not twist or force the HDMI connector into
the HDMI OUT jack.
Notes About the Discs
To keep the disc clean, handle the disc by its
edge. Do not touch the surface.
Dust, fingerprints, or scratches on the disc
may cause it to malfunction.
Do not expose the disc to direct sunlight or
heat sources such as hot air ducts, or leave it in
a car parked in direct sunlight as the
temperature may rise considerably inside the
car.
After playing, store the disc in its case.
Clean the disc with a cleaning cloth. Wipe the
disc from the center out.
Do not use solvents such as benzine, thinner,
commercially available disc/lens cleaners, or
anti-static spray intended for vinyl LPs.
If you have printed the disc’s label, dry the
label before playing.
Do not use the following discs.
– A lens cleaning disc.
– A disc that has a non-standard shape (e.g.,
card, heart).
– A disc with a label or sticker on it.
– A disc that has cellophane tape or sticker
adhesive on it.
Do not resurface the playing side of a disc to
remove surface scratches.
,continued