Sony BDV-T58 Blu-ray Player User Manual


 
Additional Information
61
US
USB device
BRAVIA Internet Video
“BRAVIA” Sync ([Control for HDMI])
A disc does not start playing
from the beginning.
•Resume play has been selected. Press OPTIONS and select [Play from
beginning], then press .
Playback does not start from the
resume point where you last
stopped playing.
•The resume point may be cleared from memory depending on the disc when
you open the disc tray.
you disconnect the USB device.
you play other content.
you turn off the unit.
The language for the soundtrack/
subtitle or angles cannot be
changed.
•Try using the BD’s or DVD’s menu.
•Multi-lingual tracks/subtitles or multi-angles are not recorded on the BD or
DVD being played.
Bonus contents or other data that
are contained in a BD-ROM
cannot be played.
• Try the following: 1 Remove the disc. 2 Turn the system off. 3 Remove and
reconnect the USB device (page 27). 4 Turn the system on. 5 Insert the BD-
ROM with BONUSVIEW/BD-LIVE.
Symptom Problems and solutions
The USB device is not
recognized.
• Try the following: 1 Turn the system off. 2 Remove and reconnect the USB
device. 3 Turn the system on.
Make sure that the USB device is securely connected to the (USB) port.
•Check if the USB device or a cable is damaged.
•Check if the USB device is on.
•If the USB device is connected via a USB hub, disconnect it and connect the
USB device directly to the unit.
Symptom Problems and solutions
The picture/sound is poor/certain
programs display with a loss of
detail, especially during fast-
motion or dark scenes.
•Picture/sound quality may be poor depending on Internet content providers.
• Picture/sound quality may be improved by changing the connection speed.
Sony recommends a connection speed of at least 2.5 Mbps for standard-
definition video and 10 Mbps for high-definition video.
• Not all videos contain sound.
The picture is small. •Press X to zoom in.
Symptom Problems and solutions
The [Control for HDMI]
function does not work
(“BRAVIA” Sync).
•Check that [Control for HDMI] is set to [On] (page 53).
•If you change the HDMI connection, turn the system off and on again.
•If power failure occurs, set [Control for HDMI] to [Off], then set [Control for
HDMI] to [On] (page 53).
• Check the following and refer to the operating instructions supplied with the
component.
the connected component is compatible with the [Control for HDMI]
function.
the connected component’s setting for the [Control for HDMI] function is
correct.
Symptom Problems and solutions