Filter
Top Products
60
US
There is no digital sound from
the HDMI OUT jack when using
the Audio Return Channel
function.
• Set [Control for HDMI] in [HDMI Settings] of [System Settings] to [On]
(page 53). Also, set [Audio Return Channel] in [HDMI Settings] of [System
Settings] to [Auto] (page 53).
• Make sure that your TV is compatible with the Audio Return Channel function.
• Make sure that an HDMI cable is connected to a jack on your TV that is
compatible with the Audio Return Channel function.
• The sampling frequency of the input stream is more than 48 kHz.
The system does not output
sound correctly when connected
to a set-top box.
• Set [Audio Return Channel] in [HDMI Settings] of [System Settings] to [Off]
(page 45).
Severe hum or noise is heard. • Check that the connecting cords are away from a transformer or motor, and at
least 10 feet (3 meters) away from your TV set or a fluorescent light.
• Move your TV away from the audio components.
• Clean the disc.
The sound loses stereo effect
when you play a CD.
• Select stereo sound by pressing AUDIO (page 34).
The surround effect is difficult to
hear when you are playing a
sound track of Dolby Digital,
DTS, or MPEG audio.
• Check the surround setting (page 27).
• Check the speaker connections and settings (pages 17, 46).
• Depending on the BD/DVD, the output signal may not be the entire 5.1 channel.
It may be monaural or stereo even if the sound track is recorded in Dolby
Digital or MPEG audio format.
The sound comes from the center
speaker only.
• Depending on the disc, the sound may come from the center speaker only.
No sound is heard from the
center speaker.
• Check the speaker connections and settings (pages 17, 46).
• Check the surround setting (page 27).
• Depending on the source, the effect of the center speaker may be less
noticeable.
• A 2 channel source is being played.
No sound or only a very low-
level sound is heard from the
surround speakers.
• Check the speaker connections and settings (pages 17, 46).
• Check the surround setting (page 27).
• Depending on the source, the effect of the surround speakers may be less
noticeable.
• Check the wireless setting (page 24).
• A 2 channel source is being played.
The beginning of the sound is cut
off.
• Set the sound mode to “MOVIE” or “MUSIC” (page 34).
• Select “A.F.D. STD” for “SUR.SETTING” (page 27).
The sound effects are disabled. • The effects of SOUND MODE, “D.BASS,” “NIGHT MODE,” and
“SUR.SETTING” may be disabled depending on the input stream (page 52).
Distortion occurs in the sound of
a connected component.
• Reduce the input level for the connected component by setting [Attenuate -
AUDIO] (page 51).
Symptom Problems and solutions