Filter
Top Products
Chapter 4 Menu Settings 4-37
Chapter 4 Menu Settings
4-6-4 Selecting the Monitor
Output Signal (MON-L SEL/MON-
R SEL)
The [F9] (MON-L SEL) and [F10] (MON-R SEL)
buttons allow you to specify the audio channel to be
output from the left and right MONITOR OUTPUT
connectors, respectively.
1: Audio channel 1
2: Audio channel 2
3: Audio channel 3
4: Audio channel 4
5: Analog cue channel
When multiple channels are selected for a single
connector, all of the numbers are displayed.
Select the output signal to be monitored as follows:
1 Press the [F9] (MON-L SEL) or [F10] (MON-R
SEL) button. The setting display section lights up.
2 Press numeric buttons 1 to 4 to select audio
channels 1 to 4, or numeric button 5 for the analog
cue channel.
Example: Pressing numeric buttons 1 and 2 selects
audio channels 1 and 2, leaving audio channels 3
and 4, and the analog cue channel off.
“12...” appears in the display.
3 To set the entered audio channels, press the
respective function button ([F9] or [F10]).
4-6-1 Selecting the Audio Input
Signal (A-IN ALL to A-IN CH4)
Function buttons [F1] (A-IN CH1) to [F4] (A-IN CH4)
select the audio input signal for the various channels.
sif: Selects the audio signal input through the
SERIAL V/A INPUT connector.
aes/ebu: Selects the audio signal input through the
AUDIO INPUT (AES/EBU) connectors.
analg: Selects the audio signal input through the
ANALOG AUDIO INPUT connectors.
4-6-2 Setting the Dolby NR
System (DOLBY NR) (DVW-A500/
1 Series Only)
The Dolby NR (noise reduction) C system, which is
used for cue audio tracks, can be turned on or off only
when using an oxide tape. The system automatically
turns on when using a metal tape. Press the [F6]
(DOLBY NR) button to change the DOLBY NR
setting.
on: Select this setting to play an analog Betacam
oxide tape with the Dolby NR system.
off: Select this setting to play an analog Betacam
oxide tape without the Dolby NR system.
4-6-3 Setting Emphasis
(EMPHASIS)
To emphasize to a digital audio signal that has been
converted from an analog audio input signal, set the
[F7] (EMPHASIS) button to on.
This setting also allows you to emphasize while
digitizing a playback audio signal from a conventional
Betacam cassette.