Filter
Top Products
67
Menu Contents
Chapter 4 Menu Settings
EE OUT PHASE settings for time code
output
Use the following as reference information when setting
the EE OUT PHASE menu item (see page 61)
.
• THROUGH mode
In this mode, the LTC signal is output with the phase
synchronized with the input time code signal. This mode
is appropriate when recording signals from multiple
devices on a number of VCRs.
When the camcorder is in genlock mode, the time code
precision is ±0 frames. When the camcorder is not in
genlock mode, it is ±1 frame.
• VIDEO INPUT PHASE mode
The time code output signal is synchronized with the
input video signal.
This mode is appropriate when the output from a single
device is recorded on a number of VCRs. The
connections are loop-through connections.
In this mode, the same time code is recorded on all of the
VCRs 1 to n.
VIDEO IN
AUDIO IN
TIME CODE IN
TIME CODE OUT
VIDEO IN
AUDIO IN
TIME CODE IN
TIME CODE OUT
VIDEO IN
AUDIO IN
TIME CODE IN
TIME CODE OUT
Composite video or S-video signal
Audio signal
Time code signal
Camcorder 1
Camcorder 2
Camcorder n
DSR-1800/1800P (1st unit)
DSR-1800/1800P (2nd unit)
DSR-1800/1800P (nth unit)
VIDEO INVIDEO OUT
VIDEO LOOP THRU
TIME CODE IN
TIME CODE OUT
VIDEO IN
VIDEO LOOP THRU
TIME CODE IN
TIME CODE OUT
VIDEO IN
VIDEO LOOP THRU
TIME CODE IN
TIME CODE OUT
Composite video or SDI (video and audio) signal
Time code signal
DSR-1800/1800P (1st unit)
DSR-1800/1800P (2nd unit)
DSR-1800/1800P (nth unit)
Output device
(VCR, camera, etc.)