Filter
Top Products
D:\SONY DVD\2591934111 DVP-
NC80V\SOURCE\DVP-
NC80V_US\01US12ADV3-CEK.fm
master page=left
62
DVP-NC80V
2-591-934-11(1)
Changing the password
1 Press DISPLAY while the player is in
stop mode.
The Control Menu appears.
2 Press X/x to select
(PARENTAL CONTROL), then press
ENTER.
The options for “PARENTAL
CONTROL” appear.
3 Press X/x to select “PASSWORD
t,” then press ENTER.
The display for entering the password
appears.
4 Enter your 4-digit password using the
number buttons, then press ENTER.
5 Enter a new 4-digit password using the
number buttons, then press ENTER.
6 To confirm your password, re-enter it
using the number buttons, then press
ENTER.
If you make a mistake entering your
password
Press C before you press ENTER and input
the correct number.
Controlling Your TV or AV
Amplifier (Receiver) With
the Supplied Remote
By adjusting the remote signal, you can
control your TV with the supplied remote.
If you connect the player to an AV amplifier
(receiver), you can control the volume with
the supplied remote.
Notes
• Depending on the connected unit, you may not be
able to correctly control your TV or AV amplifier
(receiver) using some of the buttons below.
• If you enter a new code number, the code number
previously entered will be erased.
• When you replace the batteries of the remote, the
code number you have set may be reset to the
default setting. Set the appropriate code number
again.
Controlling TVs with the remote
1 Slide the TV/DVD switch to TV.
2 While holding down [/1, press the
number buttons to select the
manufacturer’s code for your TV (see
the table below).
3 Release [/1.
VOL +/–
TV/VIDEO
TV/DVD
switch
ENTER
[/1
Number
buttons
01ΥΣ12Α∆ς3−ΧΕΚ.φµ Παγε 62 Φριδαψ, Φεβρυαρψ 25, 2005 9:50 ΑΜ