Filter
Top Products
48
Settings and Adjustments
Setting for the Signal to the Digital
Output
When you select “ON,” set “DOLBY DIGITAL,” “MPEG”
and “DTS.”
Switches the methods of outputting audio signals when
you connect a digital component such as a receiver
(amplifier) having a digital connector, an audio
component having a built-in decoder (Dolby Digital,
MPEG or DTS), a DAT or MD via the DIGITAL OUT
OPTICAL or COAXIAL connector using an optical or
coaxial digital connecting cord. For details on the
connection, see pages 11 and 12.
pDOLBY DIGITAL
Selects output Dolby Digital signals via the DIGITAL OUT
OPTICAL and COAXIAL connectors. You cannot select
this item when you set “DIGITAL OUT” to “OFF.”
•
D-PCM (Downmix PCM): when you play the Dolby
Digital sound tracks, the output audio signals are mixed
down to 2 channels. With the settings of the item
“DOWNMIX” in “AUDIO SETUP,” you can select
whether the signals conform to Dolby Surround (Pro
Logic) or not.
• DOLBY DIGITAL: when the player is connected to an
audio component with a built-in Dolby Digital decoder.
Note
If the player is connected to an audio component lacking a
built-in Dolby Digital decoder, do not set “DOLBY DIGITAL”
in “AUDIO SETUP” to “DOLBY DIGITAL.” Otherwise, when
you play the Dolby Digital sound track, a loud noise or no
sound will come out from the speakers, affecting your ears or
causing the speakers to be damaged.
AUDIO SETUP
AUDIO ATT:
AUDIO DRC:
TRACK SELECTION:
DOWNMIX:
DIGITAL OUT:
DOLBY DIGITAL:
MPEG:
To set, press , then .
To quit, press .
OFF
STANDARD
OFF
DOLBY SURROUND
ON
D-PCM
PCM
DTS:
OFF
ENTER
SETUP
pDIGITAL OUT
Selects output signals via the DIGITAL OUT OPTICAL
and COAXIAL connectors.
•
ON: Normally select this position. When you select
“ON,” set “DOLBY DIGITAL,” “MPEG” and “DTS.”
For details on setting them, see “Setting for the Signal to
the Digital Output.”
• OFF: when the player does not output the sound signals
via DIGITAL OUT OPTICAL and COAXIAL connectors,
if you select this position, the influence of the digital
circuit upon the analog one is minimum.
Notes
• When you play the sound tracks with 96 kHz sampling
frequency, the output signals from the DIGITAL OUT
(OPTICAL, COAXIAL) are converted to 48 kHz (sampling
frequency). When the signals are output from LINE OUT
(AUDIO 1, 2 ) connectors, sampling frequency stays at 96kHz
and the output signals are converted to analog signals.
• When you select “OFF,” You cannot set “DOLBY DIGITAL,”
“MPEG” and “DTS.”
Settings for Sound (AUDIO SETUP)