Filter
Top Products
63
Settings and Adjustments
Controlling the TV or the AV Receiver (Amplifier) with the
Supplied Remote Z
1/u (POWER)
Number
buttons
TV/DVD
switch
1
4
7
2
5
8
0
3
6
9
If you adjust the remote signal, you can control your TV
with the supplied remote. Default setting is to control
Sony TVs with the g mark.
When you connect the player to a Sony AV receiver
(amplifier), you can also set the input of the receiver
(amplifier) to this player with the supplied remote.
Controlling TVs with the remote
1 Slide TV/DVD switch to TV.
2 Hold down 1/u (POWER), and enter your TV’s
manufacturer’s code (see the table) using the
number buttons. Then release 1/u (POWER).
Code numbers of controllable TVs
If more than one code number is listed, try entering them
one at a time until you find the one that works with your
TV.
Notes
• If you enter a new code number, the code number previously
entered will be erased.
• When you replace the batteries of the remote commander, the
code number may reset to 01 (Sony). Reset the appropriate code
number.
Manufacturer
Sony (default)
Grundig
Hitachi
Loewe
Nokia
Panasonic
Philips
Saba
Samsung
Sanyo
Sharp
Telefunken
Thomson
Toshiba
Code
number
01
11
24
45
15,16,69
17,49
06,07,08
12,13
22,23
25
29
36
43
38