Filter
Top Products
Service Options
The EBS-SP35 is an advanced media device with the ability of communicating through an RF
network to maintain updated firmware and control. The features outlined below are advanced
functions designed for an integrated RF system.
This menu area is used to set up parameters for servicing the EBS-SP35 or performing service
functions.
Update Channel
This feature is used for setting a channel to perform firmware updates. Using the numeric
keys on the remote, enter the channel that has been identified by your system
administrator for firmware updates.
Allow Update Searching
This YES / NO selection either allows or prohibits the display from searching for an
update channel for firmware updates. Having this selected as YES will allow updates
when the Update Channel needs to be changed for some reason.
Start Firmware Update
To manually initial a firmware update, press the Right arrow button on the remote from
this menu line. The SP35 will immediately begin the firmware update process and reboot
when complete.
Note: During a firmware update, the Display and EBS-SP35 should not be unplugged or
turned off. Doing so while firmware is being downloaded and upgraded on the device
could damage the unit and make it unusable.
If the firmware update was initiated by mistake, it will time out after 3 to 5 minutes.
Restore Factory Settings
This function allows the EBS-SP35 to be reset to the factory settings. Changes, channel
lineup programming and other setup customizations will be lost and the SP35 will return
to factory settings.
Show Status
This menu item will activate a status window showing important information about the
display, EBS-SP35, firmware versions and other diagnostic data.
21
Copyright 2006 – Enseo, Inc.
15