Filter
Top Products
Sony Displays with DVI-HDCP Digital Connections
PPV Provider
Control Box
1. Connect HDMI cable to EBS-SP35
2. Connect HDMI to DVI adapter to Display Input 1
3. Connect HDMI cable to HDMI to DVI adapter
4. Connect L/R audio to SP35
5. Connect mini-jack audio to the Input 1 audio
6. Connect the Communication cable to the input
marked Display on the SP35
7. Connect the 9-pin serial connector on the
Communication cable to the input labeled Remote
on display.
8. Plug mini-jack cable to Control-S Out
9, Connect Coax cable to RF IN on SP35
10. Connect PPV provider RJ12 to PPV input on SP35
11. Plug in 12V DC power adapter
Power Supply
Note: Sony FWD-42PX2 and FWD-42PV1 have connections located on the bottom of the display and in different
configuration than shown above.
Initial Power On
When the power is applied to the EBS-SP35 with the external AC adapter, the device will power
on. The power status of the EBS-SP35 can be confirmed by viewing a lighted Green LED through
the top cover of the set-top-box.. If this light is not seen, check the connections of the power
supply.
Menus / Configuration
Stand Alone vs. Lodging Mode
The EBS-SP35 is designed to operate in a Pay-Per-View environment, connected to a lodging
system that uses protocols and commands to control the display and tuner. The EBS-SP35 may
also be able to operate in a Stand Alone mode to provide basic TV tuning for the Sony Display.
When the EBS-SP35 is connected to a compatible lodging system, the SP35 will automatically
recognize the lodging system and respond to the PPV commander. In Lodging Mode, the control
buttons and IR commands from the Sony remote will not control the
Supported Remote Controls
The EBS-SP35 is designed to function with the remote control that shipped with the Sony display.
Because of differences in the display remotes, in which not all remotes have the same available
buttons, some remotes may have limited functionality with the display remote. In such case, as
standard Sony TV remote or universal remote using Sony IR commands can control the EBS-
SP35 in Stand-Alone Mode.
21
Copyright 2006 – Enseo, Inc.
4