Filter
Top Products
29
GB
Getting Started
4 Press or b to enter the
parameter.
You can also use ENTER or i on the
receiver.
5 Press V/v repeatedly to select
“T. TONE Y”.
You can also use U or u on the receiver.
The test tone is output from each speaker
in sequence as follows:
Front left t Center t Front right t
Surround right t Surround left t Sub
woofer
6 Adjust the speaker levels and
balance using the LEVEL menu
so that the level of the test tone
sounds the same from each
speaker.
For details, see “Adjusting the level
(LEVEL menu)” (page 36).
Tips
• To adjust the level of all speakers at the same
time, press MASTER VOL +/–. You can also
use MASTER VOLUME on the receiver.
•The adjusted value are shown on the display
during adjustment.
To turn off the test tone
Repeat steps 1 to 5 above to select “T. TONE
N”.
You can also press any input buttons.
When a test tone is not output
from the speakers
• The speaker cords may not be connected
securely.
• The speaker cords may have the short-circuit
problem.