Sony KDL-32BX420 Flat Panel Television User Manual


 
42
GB
Troubleshooting
Check whether the 1 (standby) indicator is
flashing in red.
When it is flashing
The self-diagnosis function is activated.
Press 1 on the side of the TV to turn it off,
disconnect the mains lead, and inform your dealer or
Sony service centre.
When it is not flashing
1 Check the items in the tables below.
2 If the problem still persists, have your TV
serviced by qualified service personnel.
z
For further information, please contact Sony Customer
Information Centre at the address or telephone that
appears on the supplied guarantee.
Picture
No picture (screen is dark) and no sound
Check the aerial/cable connection.
Connect the TV to the mains, and press 1 on the side of
the TV.
If the 1 (standby) indicator lights up in red, press "/1.
No picture or no menu information from
equipment connected to the scart connector
Press to display the connected equipment list, then
select the desired input.
Check the connection between the optional equipment
and the TV.
Double images or ghosting
Check the aerial/cable connection.
Check the aerial location and direction.
Only snow and noise appear on the screen
Check if the aerial is broken or bent.
Check if the aerial has reached the end of its serviceable
life (three to five years in normal use, one to two years
at the seaside).
Picture or sound noise when viewing a TV
channel
Adjust “AFT” (Automatic Fine Tuning) to obtain better
picture reception (page 31).
Some tiny black points and/or bright points
appear on the screen
The picture of a display unit is composed of pixels. Tiny
black points and/or bright points (pixels) on the screen
do not indicate a malfunction.
No colour on programmes
Select “Reset” (page 26).
No colour or irregular colour when viewing a
signal from the COMPONENT IN sockets
Check the connection of the COMPONENT IN
sockets and check if each sockets are firmly seated in
their respective sockets.
Sound
No sound, but good picture
Press 2 + or % (Mute).
Check if the “Speakers” is set to “TV Speakers”
(page 28).
When using HDMI input with Super Audio CD or DVD-
Audio, DIGITAL AUDIO OUT (OPTICAL) may not
output audio signals.
Channels
The desired channel cannot be selected
Switch between digital and analogue mode and select
the desired digital/analogue channel.
Some channels are blank
Scrambled/Subscription only channel. Subscribe to the
pay TV service.
Channel is used only for data (no picture or sound).
Contact the broadcaster for transmission details.
Digital channels are not displayed
Contact a local installer to find out if digital
transmissions are provided in your area.
Upgrade to a higher gain aerial.
General
The TV turns off automatically (the TV enters
standby mode)
Check if the “Sleep Timer” (page 34) or “Idle TV
Standby” (page 35) is activated.
If no signal is received and no operation is performed in
the TV mode for 15 minutes, the TV automatically
switches to standby mode.
Distorted picture and/or sound
Keep the TV away from electrical noise sources such as
cars, motorcycles, hair-dryers or optical equipment.
When installing optional equipment, leave some space
between the optional equipment and the TV.
Check the aerial/cable connection.
Keep the aerial/cable TV cable away from other
connecting cables.
The remote does not function
Replace the batteries.
HDMI equipment does not appear on “HDMI
Device List”
Check that your equipment is compatible with control
for HDMI.
If “Store Display Mode: On” is displayed on the
screen
Your TV is set to “Shop” mode. You need to set “Home”
for “Location” in the “Auto Start-up” procedure again
(page 6).