Filter
Top Products
Basic Operations
21
Basic Operations
Changing the Wide Screen Mode
qf WIDE Press repeatedly to step through the Wide Mode settings:
Wide Zoom, Normal, Full, Zoom. The Wide Mode settings
can be also accessed in the Screen settings. See page 29.
4:3 Original source
Standard definition source
16:9 Original source
High definition source
mm
Wide Zoom Wide Zoom
Normal Normal
This mode is not available
Full Full
Zoom Zoom
When the TV receives a 720p, 1080i or 1080p
signal, Normal cannot be selected.
qg DISPLAY Press once to display the current channel number, channel
label, time and Wide Mode settings. The OSD (on screen
display) will turn off after a few seconds or press again to
immediately turn off the display.
qh V/v/B/b Press V/v/B/b to move the on-screen cursor. Press to
select/confirm an item.
qj TOOLS Press to display the Tools Menu that is associated with your
current input: Analog TV, Digital TV, External Inputs, and PC.
Each input has a different Too ls Menu. (See page 26, 28, 31,
36 and 37.)
Depending on the input signal, menus you can
select may vary.
qk JUMP Press to jump back and forth between two channels. The TV
alternates between the current channel and the last channel that
was selected among the digital or analog channels. It will not
cross over from digital to analog, or from analog to digital.
ql CH +/– Press to scan through channels. To scan quickly through
channels, press and hold down either +/–.
Button Description
qg
qf
qk
qh
qj
ql
Insert two size AA batteries (supplied) by matching the e
and E on the batteries to the diagram inside the remote
control’s battery compartment.
Push and slide to open
(see
page 29 for details)