Sony KP-43HT20, KP-53HS20, KP-53HS30, KP-61HS20, KP-61HS30 Projection Television User Manual


 
Installing and Connecting the Projection TV
18
Model name1[KP-43HT20] Model name2[KP-53HS20/30] Model name3[KP-61HS20/30]
[4-081-143-11 (1)]
Cable Box Only
Use this hookup if:
You subscribe to a cable TV system that uses scrambled or encoded
signals requiring a cable box to view all channels, and
You do not intend to hook up any other audio or video equipment to
your projection TV.
When all channels are routed through your cable box, only one unscrambled
channel is sent to the projection TV, so you cannot use the Twin View
feature. If some channels are scrambled, but others are not, consider using
the hookup on page 17 instead.
1
Connect the coaxial connector from your cable service to the cable
boxs IN jack.
2
Using a coaxial cable, connect the cable boxs OUT jack to the TVs
VHF/UHF jack.
Also, set Cable to ON in the Channel menu. (see page 52)
If you will be controlling all channel selection through your cable box,
consider using the Channel Fix feature to set your projection TV to
channel 3 or 4. (see page 53)
Your Sony remote control can be programmed to operate your cable
box. (see Programming the Remote Control on page 65)
To change channels using the cable box, set your projection TV to
channel 3 or 4 depending on the cable box channel output.
VHF/UHF
Rear of projection TV
Cable
IN
OUT
Cable box
Setting the Channel
Fix feature in the Channel
menu (see Using the
Channel Menu on page
52) ensures that you do
not accidentally switch
the channels using your
projection TV.
z