Filter
Top Products
Installing and Connecting the Projection TV
34
Model name1[KP-46WT510] Model name2[KP-51WS510] Model name3[KP-57WS510] Model name4[KP-65WS510]
[4-094-605-11]
Adjusting the Convergence Manually
The Manual Convergence feature gives you more control over the TV's
picture than the Flash Focus feature, allowing you to fine-tune the color
alignment of each section of the TV screen.
1 Press MENU to display the Menu.
2 Move the joystick B or b to highlight the Setup icon and press .
3 Move the joystick to highlight Convergence and press .
A pattern of white crosses appears, with a yellow around one of the
crosses. Aligned crosses (which do not need adjustment) look white and
have little or no red or blue showing. Crosses that are not aligned show
red or blue shades beyond their edges.
4 Using the joystick, move the to surround a cross that you want to
adjust. Press . The changes to red.
5 If the cross that you selected has red edges, move the joystick until the
red image is replaced with a white cross. Once you have finished this (or
the cross does not have red edges), press . The changes to blue.
6 If the cross you selected has blue edges, move the joystick until the blue
image is replaced with a white cross. Once you have finished this, press
. The changes to yellow again.
7 Repeat steps 4 to 6 to adjust other crosses. When finished, press MENU
to exit the manual convergence screen and the Setup menu.
✍ Before using Manual Convergence, you must first perform Flash Focus
(as described on page 33).
✍ Use the joystick of your remote control to perform the steps below.
✍ You can scroll up and down through the 9 x 7 field of crosses to
manually converge all portions of the screen.
Full/Normal
Move
<
<
<
<
Select:
End:menu
-
-
For details on using the
Setup Menu, see page 61.
z