Filter
Top Products
42
SETUP SETUP SETUPSETUP SetupSETUP
Notes on
Adjusting the
Convergence
Manually
❑ Allow the TV to warm up for about 30 minutes before you adjust
the convergence.
❑ For best results, stand about 3 to 5 feet back from the picture
when adjusting the convergence. Begin with the crosses in the
center area of the screen and, once those are adjusted, move to the
crosses on the edges of the screen.
❑ You can make separate adjustments in the each of the following
viewing modes:
❑ For standard-definition (480i/480p) sources: Wide Zoom,
Normal/Full, and Zoom modes (see page 53).
❑ For high-definition (720p/1080i) sources: Full, Wide Zoom, and
Zoom modes (see page 54); in Twin View (see page 55).
In each of these viewing modes, the cross pattern looks different,
but the adjustment procedure is the same.
❑ To optimize the conditions for convergence adjustment, in the
Video Menu, set
Mode to Pro or Movie and lower the Picture level
settings (see page 62).
❑ You can reset the adjustments by pressing the RESET button on the
remote control.
AX1X.book Page 42 Wednesday, June 30, 2004 9:21 AM