Sony KP-48V90 Projection Television User Manual


 
50
Sony KP-43T90/48V90/53S76/53V90/61V90 (US) 4-082-881-13 (1)
The picture turns off and the
TIMER/STAND BY indicator on the
front panel flashes (self-diagnosis
function)
No picture (screen not lit), no
sound
Remote control does not
operate
Dark, poor or no picture
(screen lit), good sound
Good picture, no sound
Troubleshooting
The projection TV is equipped with a self-diagnosis function. If there is a problem with your projection TV, the TIMER/STAND BY indicator on the front
panel will flash repeatedly. Counting the number of flashes helps you inform qualified Sony personnel of the projection TV’s condition.
Press POWER on the projection TV to turn it off, then inform qualified Sony personnel or the above Direct Response Center of the number of flashes.
Make sure the power cord is plugged in.
Operate with the buttons on both the projection TV and the remote control.
Check to see if the TV/VIDEO setting is correct: when watching TV, set to TV, and when watching video tapes, set to VIDEO 1, 2, 3 or 4.
Try another channel.
It could be station trouble.
Perform AUTO SET UP again using the SET UP button to return to the factory preset condition. (see To perform AUTO SET UP again on page 19)
The Parental Control feature is activated. (see To deactivate the Parental Control feature on page 37)
Batteries could be weak. Replace the batteries.
Press TV (FUNCTION) when operating your projection TV.
Make sure the projection TVs power cord is connected securely to the wall outlet.
Locate the projection TV at least 3-4 feet away from fluorescent lights.
Check the polarity of the batteries.
Adjust Picture in the Video menu. (see Picture Adjustment on page 26)
Adjust Brightness in the Video menu. (see Picture Adjustment on page 26)
Check antenna/cable connections.
Perform AUTO SET UP again using the SET UP button to return to the factory preset condition. (see To perform AUTO SET UP again on page 19)
Adjust the convergence again using the FLASH FOCUS button. (see Adjusting the Convergence Automatically (FLASH FOCUS) on page 19)
Press MUTING so that Muting disappears from the screen. (see MUTING on page 20)
Check the MTS/SAP setting in the Audio menu. (see MTS/SAP on page 27)
Make sure Speaker is set to On in the Audio menu. (see Speaker on page 28)
Perform AUTO SET UP again using the SET UP button to return to the factory preset condition. (see To perform AUTO SET UP again on page 19)
If, after reading the following instructions, you have additional questions related to the use of your Sony projection TV, please call one of the following
numbers (English only).
Customers in the continental United States contact the Direct Response Center at: 1-800-222-SONY (7669)
Customers in Canada contact the Customer Relations Center at: (416) 499-SONY (7669)
01GB12SPC-E.P65 3/9/02, 3:47 PM50