Filter
Top Products
Programming the Remote Control
The remote control is preset to operate Sony brand video equipment.
- - I”.. I
Sony
Switch Position
l+&ram~inable
Equipment
on Remote Control
Code Number
Beta, ED Beta VCRs
AV1
303
8 mm VCR
AV2
302
VHS VCR
AV3
301
DVD Player
DVb
751 -
If you have video equipment other than Sony brand that you want to control
with the projection TV’s remote control, use the following procedures to
-3
-4
-5
From the “Manufacturer’s Codes” listed on page 67, select the three-digit
code number for the manufacturer’s code for your component. If more than
one code number is listed, start with the number listed first. Use the code
number to complete the following procedure.
To program a cable box or a satellite receiver
1
2
3
4
5
6
Open the panel of the remote control.
Press
CODE SET
inside the panel.
Close the panel and press
SAT/CABLE (FUNCTON).
Enter the three-digit manufacturer’s code number using the O-9 buttons.
Press
ENTER.
To check if the code number works, aim the projection TV’s remote
control at the component and press the green
POWER
button that
corresponds with that component. If it responds, the programming is
completed. If not, try using the other codes listed for that manufacturer.
(Continued)
65