Filter
Top Products
Sony KV-DZ29M91 Group D3 (GB-dummy)_2-890-006-E2 (1)
G Troubleshooting
If you find any problem while viewing your TV, you can either use the “Factory
Settings” function (see O) or check the Troubleshooting guide below. If the
problem persists, contact your Sony dealer.
Snowy picture, noisy sound
• Check the antenna setup and other connections.
• Preset the channel manually again (see N).
• Set the “Signal Booster” to “Auto” (see N) or try using an external booster.
Distorted picture, noisy sound
• Set the “Signal Booster” to “Off” (see N), or turn off or disconnect any external booster in
use.
Good picture, noisy sound
• Select the appropriate “TV System” (see N).
No picture, no sound
• Check the power cord, antenna setup and other connections.
• Press 4/1 (power) to turn on the TV.
• Press ! (main power) on the TV to turn off the TV for about five seconds, then turn it on
again.
Good picture, no sound
• Press 2 + to increase the volume level or press to cancel the muting.
Dotted lines or stripes
• Do not use a hair dryer or other equipment near the TV.
• Check the antenna setup.
Double images or “ghosts”
• Use the fine tuning (“Fine”) function (see N).
• Check the antenna setup or use a highly directional antenna.
• Turn off or disconnect any external booster in use.
No color
• Adjust the “Color” level from “Picture Adjustment” (see K).
• Select the appropriate “Color System” (see O).
• Check the antenna setup.
Picture slant
• Keep external speakers or other electrical equipment away from the TV. The magnetic
disturbance from these equipments or the direction of the earth’s magnetic field may affect
the TV.
• Adjust the “Picture Rotation” or “Picture V-Position” (see O).
Abnormal color patches
• Keep external speakers or other equipment away from the TV. Do not move the TV while
the TV is turned on. Press ! (main power) on the TV to turn off the TV for about 15
minutes, then turn it on again to demagnetize the TV.
TV cannot receive stereo broadcast sound or stereo broadcast sound switches on and off or is distorted.
• Check the antenna setup and other connections.
Teletext display is incomplete (snowy picture or double images).
• Check the antenna setup and other connections.
• Set the “Signal Booster” to “Auto” (see N) or try using an external booster.
• Use the fine tuning (“Fine”) function (see N).
01GB03INS-SOEMRus.p65 14/05/2007, 10:34 AM8
Black