Filter
Top Products
– 13 –
KV-G21L3
RM-883
2-6. PICTURE TUBE REMOVAL
•REMOVAL OF ANODE-CAP
NOTE : After removing the anode short circuit the anode of the picture tube and
the anode cap to the metal chassis, CRT shield or carbon paint on the
CRT.
•REMOVING PROCEDURES
1 Turn up one side of the rubber cap in the direction indicated by the arrow a.
a
a
3 C board
1 Anode cap
Cushion
2 A board
4 Deflection yoke
5 Four screws
(Tapping screws)
b
b
2 Using a thumb press down then pull up the rubber cap firmly in the direction
indicated by the arrow b.
3 When one side of the rubber cap is separated from the anode button, the
anode-cap can be removed by turning up the rubber cap and pulling it up in the
direction of the arrow c.
c
Anode button
• HOW TO HANDLE AN ANODE-CAP
1 Do not damage the surface of anode-caps with sharp shaped objects
2 Do not press the rubber too hard so as not to damage the inside of anode-caps
A metal fitting called the shatter-hook terminal is built into the rubber.
3 Do not turn the foot of rubber over too hard
The shatter-hook terminal will stick out or damage the rubber.
Anode Button