Filter
Top Products
35 (GB)
Selecting the On-screen
Language
You can select the on-screen language from among
English, German, French, Italian, Spanish or
Japanese.
1 Press MENU.
The main menu appears on the display panel.
ENTER
MENU
MA I N MENU
INPUT SELECT
PIC CONTROL
PIC SIZE
CONF I G
MEMORY
REMOTE
STATUS
SELECT SET END
2 Press
v
/
V
to move the cursor (B) to “CONFIG”
and press ENTER.
The CONFIG (1/2) menu appears on the display
panel.
ENTER
MENU
CONF I G( 1/2)
DISPLAY : ON
W-VGA : OFF
CLOSED CAPTION: OFF
COLOR SYSTEM : AUTO
SCREEN F I LL :CENTER
POWER CONTROL
SCREEN SAVER
SELECT SET END
YUV LEVEL : SMPTE
3 Press
v
/
V
to move the cursor (B) to
“LANGUAGE” on the CONFIG (2/2) menu and
press ENTER.
The following menu appears on the display panel.
ENTER
MENU
LANGUAGE
ENGL I SH
DEUTSCH
FRANÇAIS
ITALIANO
ESPAÑOL
SELECT SET END
Using the Memory Function / Selecting the On-screen Language
2 Select a memory number (01 to 20) with
v
/
V
and press ENTER.
The second page of the stored settings appears on
the display panel.
ENTER
MENU
LOAD/No. 01 [··········]
-RGB/
fH
3 1.5
kHz
/fV59.9
Hz
/POL[N/N]-
CHROMA : 00
PHASE : 00
PICTURE AGC : ON
SHARPNESS : MI D
HLINEARITY : 00
VLINEARITY : 00
DOT PHASE : 50
TOTAL H PIXEL : 800
SELECT SET END
The signal type and the color system or horizontal/
vertical frequency are displayed in cyan (showing
that the signal type of the selected memory
number is the same as that of the current setting
and you can call up the stored setting) or in red
(showing that the signal type of the selected
memory number is not the same as that of the
current setting and you cannot call up the stored
setting).
3 Press ENTER.
The “LOAD COMPLETED” message appears for
about five seconds and the picture is adjusted to
the selected setting.
Note
If the loading fails, the “LOAD ERROR” message
appears on the display panel. Try to load the setting
again.