Filter
Top Products
30
Messages
If the following error messages flash in the display window, check the chart below.
Error message
BLANK
ERROR
FULL
SAVING
EDIT
BUSY
HiDCin
HOLD
LoBATT
MEMORY
Meaning/Remedy
• An MD with no recording on it is inserted.
b Insert a recorded MD.
• The disc is damaged or does not contain proper recording or
editing data.
b Reinsert the disc. If this fails, rerecord.
• There is no more space to record on the disc (less than 12 seconds
available).
b Replace the disc.
• You tried to enter more than 200 letters to label a single track or
disc.
• You tried to enter a total of more than 1700 letters for track or disc
names during playback or stop.
• You tried to enter a total of more than 500 letters for track or disc
names during a single recording.
b Enter the characters within the limit.
• The recorder is recording information (sounds) from the memory to
the disk.
b Wait until this process is completed. Do not expose the recorder
to any physical shock, nor disrupt power supply.
• The recorder is recording information (track start and end position)
from the memory to the disk.
b Wait until this process is completed. Do not expose the recorder
to physical shock, nor disrupt power supply.
• You tried to operate the recorder while it was accessing the
recorded data.
b Wait until the message goes out (in rare cases, it may take 2–3
minutes).
• Voltage of the power supply is too high.
b Use the AC-E45HG (not supplied).
• The recorder is locked.
b Slide HOLD against the arrow to unlock the recorder (page 17).
• Batteries are weak.
b Charge the rechargeable batteries or replace the dry batteries
(pages 23, 24).
• You tried to record when there is no indication in the display, with
the recorder placed where it receives continuous vibration.
b Put the recorder on a stable place, and start recording again.