Sony KP-FS53 Projection Television User Manual


 
50
Additional Information
Troubleshooting (continued)
Check the power cord, antenna and
the VCR connections.
•Press I/1 on the remote.
•Press ! on the projection TV to turn
off the projection TV for about five
seconds, then turn it on again.
•Press 2 + to increase the volume
level.
•Press % to cancel the muting.
•Press A/B until a better sound is
heard.
•Press or .
Do not use a hair dryer or other
equipment near the projection TV.
Adjust the antenna direction for
minimum interference. Contact a
Sony dealer for advice.
Use a highly directional antenna.
Use the fine tuning (“FINE”) function.
Adjust the antenna direction. Contact
a Sony dealer for advice.
•Turn off or disconnect the booster if it
is in use.
Display the “PICTURE” menu and select
“ADJUST” of “PICTURE MODE”, then
adjust the “COLOR” level.
Display the “SETUP” menu and
check the color system (“COL SYS”)
setting (usually set this to “AUTO”).
Adjust the antenna direction. Contact
a Sony dealer for advice.
No picture
No sound
Good picture
No sound
Dotted lines or
stripes
Double images or
“ghosts”
No color
The power cord, antenna
or VCR is not connected.
The projection TV is not
turned on.
The volume level is too
low.
The sound is muted.
The broadcast signal
has a transmission
problem.
The sound of the right
picture is selected
when TWIN pictures
are displayed.
There is local
interference from cars,
neon signs, hair dryers,
power generators, etc.
Broadcast signals are
reflected by nearby
mountains or buildings.
The antenna direction
needs adjustment.
Use of a booster is
inappropriate.
• The color level setting
is too low.
The color system
setting is
inappropriate.
• The antenna direction
needs adjustment.
Possible cause
Symptom
Solutions
Page
6
15
16
16
16
26
21
46
38
43