Filter
Top Products
18
Operating with the remote control
Point the remote control at the remote sensor and
press the buttons.
Distance:About 7 m (23 ft) from the front of the
remote sensor
Angle :About 30° in each direction of the front of
the remote sensor
* Do not expose the remote sensor of the recorder to a
strong light source such as direct sunlight or other
illumination. If you do so, you may not be able to
operate the recorder via the remote control.
Notes
• Do not drop or give the remote control a shock.
• Do not leave the remote control near an extremely hot or
humid place.
• Do not spill water or put anything wet on the remote control.
• Do not disassemble the remote control.
30°
30°
Introduction
Preparation of the remote control
1
Open the cover.
2
Insert batteries (AAA size).
Make sure to match the + and – on the
batteries to the marks inside the battery
compartment.
3
Close the cover.
Caution
• Never throw batteries into a fire.
Notes
• Be sure to use AAA size batteries.
• Batteries should always be disposed of with the
environment in mind. Always dispose of batteries in
accordance with applicable laws and regulations.
• If the remote control does not operate correctly, or if the
operating range becomes reduced, replace batteries with
new ones.
• When necessary to replace batteries in the remote control,
always replace both batteries with new ones. Never mix
battery types or use new and used batteries in
combination.
• Always remove batteries from the remote control if they are
dead or if the remote control is not to be used for an
extended period of time. This will prevent battery acid from
leaking into the battery compartment.
Within about 7 m (23 ft)
RD-XS35SU/SC_Inst_E_p02-18 06.2.13, 4:33 PM18