Filter
Top Products
247
Additional Information
Others
Symptom
A beep sounds, and the error
message “Import full data from
NAVITUS Design using the
“Memory Stick” or USB.” appears.
Remedy
•A problem with the project file may have
occured.
Transfer full data to the Remote Commander
with USB by connecting the USB cable and the
AC power adaptor, or read full data from a
“Memory Stick.” If the same message appears
repeatedly reqardless of how many times you
transfer/read full data, the capacity of full data
written from “NAVITUS Design” may exceed
the free memory capacity of the Remote
Commander. In this case, reduce the capacity of
full data by deleting any unnecessary
components with “NAVITUS Design,” or avoid
using image files imported for wallpapers/
skins as much as possible, and then try to write
full data to the Remote Commander again.
When transferring or reading full data is
complete, the message “Finished. Restarting.”
appears. Press the [OK] key, and wait until the
Remote Commander starts. When this message
appears, set the system clock again after the
Remote Commander restarts.