Filter
Top Products
38
Basic Operations of the Remote Commander
Continued
3
Press a function key on the
Component display or a
button on the Remote
Commander.
For example, press the [TV POWER] key.
The remote control signal is sent to the
component you want to operate (in this
case, a TV), and the component functions.
To change the page of the display
Press the NEXT button on the Remote Commander to display the next page, or
press the BACK button to display the previous one.
z Tip
It is recommended that you turn off the display by pressing the COMMANDER OFF
button after using to save the battery charge.
To lock the operation mode (Operation Lock)
You can lock the keys and buttons on the Remote Commander to prevent
operation with the Remote Commander.
Lock the operation mode in the Home display.
1
Show the Home display.
2
While pressing the
EXIT
button, press
and hold the
VOL–
button.
3
While pressing the above two
buttons consecutively, press the
CH–
button.
The operation mode is locked.
Operations cannot be performed if you press keys or buttons when the
operation mode is locked.
If you press any key or button, a beep sounds twice.
Note
Even if you connect the USB cable or insert a “Memory Stick” when the operation mode is
locked, the USB cable or a “Memory Stick” cannot be detected by the Remote Commander.
Before connecting the USB cable or inserting a “Memory Stick”, unlock the operation
mode.
To unlock the operation mode
Perform steps 2 and 3 described above. The operation mode is unlocked.
EXIT
VOL– CH–