Filter
Top Products
8
Setting up other
speakers
For greater flexibility in the positioning of the
speakers, use the optional WS-FV10,
WS-TV10, or WS-WV10 speaker stand
(available only in certain countries).
SA-VE505/VE502 only
You can attach the supplied foot pads to the
bottom of the speakers, one in each corner.
SA-VE305/VE302 only
You can hang or install the front (and rear)
speakers on a wall using hooks or nuts
(commercially available).
Note
You are responsible for the proper selection and use
of mounting hardware that you purchase at a
hardware store, and for the proper and safe
mounting of the speakers.
Tip (for SA-VE505/VE305)
The height of the front speakers should be adjusted
to about the center of the TV screen.
Positioning the speakers
(continued)
Listening to the sound
!
!
ON/STANDBY
POWER
U
First, turn down the volume on the amplifier.
The volume should be set to minimum before
you begin playing the program source.
1 Turn on the amplifier and select the
program source.
2 Press ! on the subwoofer.
The ! indicator on the subwoofer lights
up green.
3 Play the program source.
Power turns on and off
automatically
— Auto power on/off function
(SA-VE505/VE502 only)
When the subwoofer is on (i.e, the
! indicator lights up green) and there is no
signal input for a few minutes, the
! indicator changes to red and the
subwoofer enters power saving mode. While
in this mode a signal is input to the
subwoofer, the subwoofer automatically
turns on (auto power on/off function).
To turn this feature off, slide the POWER
SAVE switch on the rear panel to OFF.
AUTO
OFF
POWER
SAVE
Note
If you turn down the volume level of the subwoofer
too low, the auto power on/off function may
activate, causing the subwoofer to enter power
saving mode.
WS-FV10 WS-TV10 WS-WV10
(for rear
speakers)
Hook
SA-VE505/VE502 SA-VE305/VE302
! indicator ! indicator
Nuts (M5)
60 mm