Filter
Top Products
19
Getting Started
Getting Started
Disabling unwanted programme positions
After presetting channels, you can disable unused programme positions. The
disabled positions will be skipped later when you press the PROG +/–
buttons.
1 In step 7 above, press >/. repeatedly to display the number “00”
beside CHANNEL SET.
2 Press MENU to exit the menu.
Selected programme
position
If the picture is not clear
Normally, the Auto Fine Tuning (AFT) function automatically tunes in
channels clearly. If, however, the picture is not clear, you may also use the
manual tuning function.
1 Press PROG +/– to select the programme position for which you cannot
obtain a clear picture.
2 Press MENU, then select SETTINGS and press OK.
3 Select TUNER, then press OK.
4 Select FINE TUNING, then press OK.
The fine tuning meter appears.
5 Press ?// to get a clearer picture, then press MENU to exit the
menu.
Note that the AFT (Auto Fine Tuning) setting switches to OFF.
Tip
• If you want to return to the previous menu, highlight RETURN and press OK.
Note
• The menu disappears automatically if you don’t proceed for more than a few
minutes.
SET :
MENUEXIT :
TUNER
C
27
PROG.
NORMAL / CATV
CHANNEL SET
SYSTEM
AFT
FINE TUNING
NORMAL
D / K
RETURN
4