Filter
Top Products
83
Settings and Adjustments
◆BALANCE
Varies the balance of the left and right
speakers. Be sure to set “TEST TONE” to
“ON” for easy adjustment.
The default adjustments are in parentheses.
◆LEVEL
Varies the level of each speaker. Be sure to
set “TEST TONE” to “ON” for easy
adjustment.
The default adjustments are in parentheses.
To adjust the volume of all the speakers at
one time
Use the amplifier’s (receiver’s) volume
control.
◆TEST TONE
The speakers will emit a test tone. Use this
when you use the 5.1CH OUTPUT jacks and
adjust the “BALANCE” and “LEVEL.”
Adjusting the speaker volume
and level
1 Select “SPEAKER SETUP” in the Setup
Display.
2 Select “TEST TONE” and set to “ON.”
You will hear the test tone from each
speaker in sequence.
3 From your listening position, select
“BALANCE” or “LEVEL” and adjust the
value of “BALANCE” using C/c and
“LEVEL” using X/x.
The test tone is emitted from both left and
right speakers simultaneously.
4 Select “TEST TONE” and set to “OFF”
to turn off the test tone.
Note
The test tone signals are not output from the digital
jack.
FRONT
(0 dB)
Set this between –6 dB [L] and
+6 dB [R] (0.5 dB increments).
REAR
(0 dB)
Set this between –6 dB [L] and
+6 dB [R] (0.5 dB increments).
FRONT (0 dB) Set this between –6 dB and 0
dB (0.5 dB increments).
CENTER
(0 dB)
Set this between –12 dB and
0 dB (0.5 dB increments).
REAR (0 dB) Set this between –12 dB and
0 dB (0.5 dB increments).
SUBWOOFER
(0 dB)
Set this between –10 dB and
+10 dB (0.5 dB increments).
OFF
The test tone is not emitted
from the speakers.
ON The test tone is emitted from
each speaker in sequence while
adjusting balance or level.