Filter
Top Products
33
GB
Using the Menu
Audio Filter Improves the sound for individual channels in the case of distortion
in mono broadcasts. Sometimes a non-standard broadcast signal
can cause sound distortion or intermittent sound muting when
watching mono programmes.
1 Press M/m to select “Low” or “High”, then press OK.
If you do not experience any sound distortion, we recommend
that you leave this option set to the factory setting “Off”.
2 Press OK to select “Confirm”, then press OK.
Note
• You cannot receive stereo or dual sound when “Low” or “High”
is selected.
• Not available when “System” is set to “L”.
Skip Skips unused analogue channels when you press PROG +/- to
select channels. (You can still select a skipped channel using the
number buttons.)
1 Press M/m to select “Yes”, then press OK.
2 Press OK to select “Confirm”, then press OK.
To restore a skipped channel, select “No” in step 1.
Decoder Records the scrambled channel selected when using a decoder
connected to the scart connector / 2 either directly or via a
VCR.
Note
Depending on the country/region selected for “Country” (page 29), this
option may not be available.
1 Press M/m to select “On”, then press OK.
2 Press OK to select “Confirm”, then press OK.
To cancel this function afterwards, select “Off” in step 1.
ATT Attenuates the RF signal. In case of a strong RF signal, some video
interference may be displayed.
1 Press m/M to select “On”, then press OK.
2 Press OK to select “Confirm”, then press OK.
Tip
This option cannot be used if “AV2 Output” is set to “D-TV” (page 26)
Option Description
Continued