Filter
Top Products
27
Connecting and Setting the TV
Connecting a Satellite Receiver and a VCR
Disconnect all power sources before making any connections.
1 Connect the satellite antenna cable to the satellite receiver’s SATELLITE
IN jack.
2 Connect the CATV cable to the VCR’s VHF/UHF IN jack.
3 Using the supplied 75-ohm coaxial cable, connect the VCR’s OUT jack
to the TV’s VHF/UHF jack.
4 Using A/V and S VIDEO cables, connect the satellite receiver’s AUDIO
and S VIDEO OUT jacks to the VCR’s AUDIO and S VIDEO IN jacks.
Tip
If your VCR or satellite receiver is not equipped with S VIDEO, use a VIDEO cable
(yellow) instead of the S VIDEO cable.
5 Using A/V and S VIDEO cables, connect the VCR’s AUDIO and S
VIDEO OUT jacks to the TV’s AUDIO and S VIDEO IN jacks (VIDEO
1 IN or VIDEO 3 IN).
Note
When you connect video equipment to both the VIDEO and the S VIDEO input jacks, make sure
“Auto YC” in the
(Setup) menu is set to “On” to view the S VIDEO input (see page 25).
Tips
•You can also use the VIDEO 2 IN jacks located on the front of the TV to connect your VCR.
• Be sure your VCR’s video input is set correctly. Consult your VCR’s operating manual for
instructions.
• Use VIDEO 1/2/3 on the remote control to select VIDEO 1 IN (or VIDEO 3 IN if you use
the VIDEO 3 IN jacks for this hookup) to watch satellite TV or to watch a tape on the VCR
(your VCR must be turned on).
VHF/UHF
CENTER SPEAKER
IN
180W (6 ) MAX
VIDEO IN
HD/DVD IN
AUDIO OUT
(
VAR /FIX
)
VIDEO
P
B
YL
L
RP
R
S VIDEOAUDIO
AUDIO
1
3
4
R
L
(
MONO
)
R
VIDEO (yellow)
AUDIO-R (red)
VCR
S VIDEO
75-ohm coaxial
cable (supplied)
AUDIO-L (white)
A/V cable
(not supplied)
Satellite Receiver
CATV cable
S VIDEO
cable
(not supplied)
A/V cable
(not supplied)
75-ohm coaxial
cable (supplied)
S VIDEO cable
(not supplied)
Satellite
antenna
cable
Rear of TV