Filter
Top Products
14
-EN
Getting Started
Connecting a DVD player with component video output connectors
Component video terminals Y/CB/CR provide a
sharper, higher resolution picture by reducing the
amount of signal processing thus creating a more
accurate reproduction of the source.
If your DVD player has component video output
connectors, connect them to VIDEO 4 IN on the
projection TV in the following way.
Notes
• Connect your DVD player directly to your TV. Connecting the
DVD player through other video equipment will cause
unwanted picture noise.
• When the DVD player is connected using VIDEO 4 IN, its
MONITOR OUT signals cannot be output.
• Some DVD player connectors may be labeled Y, B-Y, and R-Y.
In this case, connect Y (green) on the projection TV to Y on the
DVD player, C
B (blue) to B-Y, and CR (red) to R-Y.
• The jacks of this projection TV are colored in green (Y), blue
(C
B), and red (CR). If line output connectors of your DVD player
have different colors, make connections according to their
labels.
• Because the high quality pictures on a DVD disc contain a lot of
information, picture noise may appear. In this case, reduce the
SHARPNESS level in the VIDEO menu (see SHARPNESS on
page 31).
• If the incorrect colors appear when using this component video
input, recheck the connections they may be reversed.
Rear of projection TV
DVD
Audio
outputs
Component video
outputs
RK-74A
(not supplied)
VMC-10HG
(not supplied)
CR (red)
CB (blue)
Y (green)
AUDIO-R (red)
AUDIO-L (white)
LINE OUT
S VIDEO OUT COMPONENT VIDEO OUT
S-LINK
DIGITAL OUT
OPTICAL COAXIALR-AUDIO 1-L VIDEO
YC
B
C
R
C
B
C
R
Y
CONTROL S
OUT
L
R
AUDIO
VIDEO 4
IN
VIDEO4
TV OUT
VIDEO1
VIDEO3
S-LINK