Sony KP 65WV700 Projection Television User Manual


 
28
SETUP SETUP SETUPSETUP SetupSETUP
VCR and Cable Box For best results, use this connection if:
Your cable company scrambles some channels, such as premium
channels (which requires you to use a cable box), but does not
scramble all channels.
With this connection you can:
Use the TV remote control to change channels coming through
the cable box. (You must first program the remote control for
your specific cable box; see Programming the Remote Control
on page 51.)
Use the TV remote control to change channels coming directly
into the TVs VHF/UHF jack. (The TVs tuner provides a better
signal than the cable box.)
Record channels coming through the cable box and channels
coming directly into the TV.
To connect a VCR and cable box, you need:
A splitter, which is a small, inexpensive device that you can
purchase at your local electronics store.
Three coaxial cables.
One A/V cable or one S VIDEO cable with audio cables.
To connect the VCR and cable box
1 Connect the CATV cable to the single (input) jack of the splitter.
2 Use a coaxial cable to connect one of the splitters two output
jacks to the TVs VHF/UHF jack.
3 Use a coaxial cable to connect the splitters other output jack to
the cable boxs input jack.
4 Use a coaxial cable to connect the cable boxs output jack to the
VCRs RF input jack.
5 Use an A/V cable to connect the VCRs A/V output jacks to the
TVs A/V input jacks.
6 Run the Auto Setup program, as described in Setting Up the
Channel List on page 43.
About Using This Connection with Dual Picture (Twin View, etc.) Features
With this connection, you can use all the dual picture features.
Using
S VIDEO jacks?
See page 25.