Filter
Top Products
94
Other Info SETUP WelcomeSETUP SETUPSETUP
General
Problem Possible Remedies
How to reset TV to
factory settings
❏ Turn on the TV. While holding down the RESET button on the remote
control, press the POWER button on the TV. (The TV will turn itself off, then
back on again.) Release the RESET button.
How to restore Video settings
to factory settings
❏ Press the RESET button on the remote control while in the Video Menu (see
page 72).
How to restore Audio
settings to factory settings
❏ Press the RESET button on the remote control while in the Audio Menu (see
page 74).
Cannot cycle through the
other video equipment
connected to the TV
❏ Be sure the Video Label option is not set to Skip (see page 84).
Cannot operate Menu ❏ If a menu option appears in gray, this indicates that the TV is in a state in
which the menu option is not available.
Lost password ❏ In the password screen (see page 80), enter the following master password:
4357. The master password clears your previous password; it cannot be
used to temporarily unblock channels.
LED on front panel is lit ❏ The STAND BY LED (see page 14) blinks when the TV is turned on, then
shuts off when the picture is displayed. If the LED blinks continuously, this
may indicate the TV needs service.
❏ The TIMER LED (see page 14) indicates that the timer is set. When the
timer is set, this LED will remain lit even when the TV is turned off.