Filter
Top Products
Installing the TV
13
Cable Box Only
Use this hookup if:
❑ You subscribe to a cable TV system that uses scrambled or
encoded signals requiring a cable box to view all channels, and
❑ You do not intend to hook up any other audio or video
equipment to your TV.
When all channels are routed through your cable box, only one
unscrambled signal is sent to the TV, so you cannot use the Twin
View feature. If some channels are scrambled, but others are not,
consider using the hookup on page 12 instead.
1 Connect the coaxial connector from your cable service to the
cable box’s IN jack.
2 Using a coaxial cable, connect the cable box’s OUT jack to the
TV’s VHF/UHF jack.
To use the cable box
❑
Have the TV tuner set to channel 3 or 4 (as appropriate) and then
use the cable box to change channels.
To use the TV remote control to switch channels on the cable box
❑
Program the remote control as necessary. For details, see
“Programming the Remote Control” on page 50.
To prevent accidental switching of TV channels
❑
Use the Channel Fix feature to lock in a channel. The Channel Fix
feature is under the Channel menu. For details, see “Using the
Channel Menu” on page 40.
1
2
Rear of TV
OUT
Cable box
IN
CATV cable
VHF/UHF