Filter
Top Products
7 (GB)
If you intend to install a TV that is not specified on page 2, be
sure to refer to the leaflet supplied with your TV.
For KDL-46X3500, KDL-46X3000, KDL-46W3000, KDL-
46V3000, KDL-40X3500, KDL-40X3000, KDL-40W3000,
KDL-40V3000 users, the procedures for adjusting the
position of the Support Frame are not necessary. Follow from
part 3 of this Step.
Step 3:
Preparing for the
installation of the TV
1
Detach the Beam and the
Support Frame.
Note
Be careful not to drop the Beam and the Support Frame when
detaching them.
2
Adjust the position of the
Support Frame.
A
For KDL-52X3500, KDL-52W3000
1 Attach the Support Frame to the Support Base
matching the holes of the Support Frame to the pins
of the Support Base, and secure the eight screws
removed in part 1, as shown in the illustration.
2 Align hole “B” of the Beam and hole “B” of the
Support Frame and secure with the four screws
which were removed in part 1.
Support Frame
Beam
Support Base
B
For KDL-52X2000, KDL-46X2000, KDL-
40X2000
1 Reverse the Support Frame to make the “Y”
marking face front. Then attach the Support Frame
to the Support Base
matching the holes of the
Support Frame to the pins of the Support Base, and
secure
the eight screws removed in part 1, as shown
in the illustration.
2 Align hole “C” of the Beam and hole “C” of the
Support Frame and secure with the four screws
which were removed in part 1.
Note
When using an electric screwdriver, set the torque setting to
approximately 1.5 N·m {15 kgf·cm}.
Support Frame
Beam
Support
Base
Pin
Support Frame
Beam
Support
Base
Pin
(Continued)